7.1 after repair unregistered...
in [LabView]
|
Prev: Necessary Matlab compiler options to integrate generated dll inVI
Next: Updating filter setting in Hottinger HBM software CATMAN frominside LABVIEW
From: gwd on 5 May 2008 22:40 After repair of the 7.1.1 runtime engine, splash screen said unregistered. Edited the registry to put in serial number. Now the serial number is on the splash screen and it says unregistered too. What gives? Does this matter? Is this whole installation going to stop working?
From: altenbach on 6 May 2008 01:40 I don't remember any registration in the 7.1.1 runtime engine. Are you sure you did not install e.g. an evaluation or regular version of LabVIEW?
From: gwd on 6 May 2008 08:40
I had a fully registered 7.1 installation. I repaired the 7.1.1 runtime engine because of another problem. No registration asked for. The installation apparently became unregistered because this is what it said on the startup screen. I looked up this problem and the knowledgebase said edit the registry key or reinstall. I edited the registry key and now I have (see attached). Also the links under programs don't work although Labview starts when clicking a vi. Maybe it's just so screwed up there's no choice but reinstall. This all started when I ill-advisedly ran an installer. Message Edited by gwd on 05-06-2008 07:33 AM splash screen1.gif: http://forums.ni.com/attachments/ni/170/321343/2/splash screen1.gif |