Cisco
in [Network]
|
Cisco WAAS Cheatsheet http://pandaeatsbamboo.blogspot.com/2008/03/cisco-waas-cheatsheet.html ... 5 Apr 2008 16:00
Mobile Telepresence on Cisco NERV http://pandaeatsbamboo.blogspot.com/2008/04/mobile-telepresence-on-cisco-nerv.html ... 5 Apr 2008 15:27
Seeking recommendations for a good book of CCNA lab exercises. Hi, I'm studying to renew my CCNA certification. I'm looking for recommendations on a good book (or any other source) of CCNA Lab Exercises. I'm reading through the Lammle CCNA prep book now. It's been so long since I have done any serious router work that I have just started reading from page one. I have a ser... 4 Apr 2008 14:38
VPN Errors on multilink T1 - but inly for DHCP and not static NAT users? I have a Cisco 1700 router with dual WIC/T1's LAN users are assigned NAT IP addresses from the Cisco 1700 via DHCP from 10.0.0.100 to 10.0.0.200. 10.0.0.2 - 10.0.0.15 are 1:1 configured to our 16 internet routable IP addresses. Users who receive an IP address via DHCP have all desired functionality, includi... 4 Apr 2008 12:23
Configuring Cisco for LACP and Trunking? We're trying to configure our Cisco 4507 to allow a new Dell server with a pair of Broadcom Gig NIC's to aggregate its NIC's to give us a 2gbps link. So far we seem to have got the team and LACP up and enabled, but the adaptor that the Broadcom Admin Util creates for the team is only showing a 1gbps connecti... 8 Apr 2008 13:15
802.1x with ACS and Third Party Switch I want do use the Cisco ACS for 802.1x authentication with a Third Party Switch (Alcatel). With a Cisco switch everything works fine. This is also true with the Alcatel Switch as long as I set the Radius Type in the ACS to IETF. Put for some purpose I need VSAs (RADIUS Vendor-Specific Attributes). So I created ... 4 Apr 2008 10:40
SPAN port on Cat 4006 Hi Group, I am trying to setup a SPAN port on a Cisco Cat 4006 running CATOS, however when I establish the SPAN port it shuts of the interface so I can no longer ping the device. Is this normal behavior or am I missing something? (enable) sh ver WS-C4006 Software, Version NmpSW: 7.4(2) Copyright (c) 1995-... 4 Apr 2008 09:33
Strange Cisco 2801 boot problem Hi! I changed compoactflash cards on one of our cisco 2801's power connected trying to get a 512MB card partitioned to 128MB to work, and when I Installed this 512MB card, router dropped suddenly to rommon. I Switched power off and tried to boot with original Card but router finds image and decompresses and loa... 4 Apr 2008 07:32
Error : memory requirements exceed available memory Hi, everyone... I was using my Cisco and it was disconnected. But two days later, when I tried to turn it on again, now it shows me the following message : System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1) Copyright (c) 1999 by cisco Systems, Inc. TAC:Home:SW:IOS:Specials for info C2600 platform... 3 Apr 2008 20:52
Backup Satellite connection I work for a company that has several thousand stores and in an effort to get them off of dialup, we've designed a configuration that would make a Cisco 877 the default gateway, but on the same network would be a VSAT router. If the DSL connection goes down on the 877, a floating route is inserted to route back ou... 7 Apr 2008 15:09 |