Prev: bad PBR sig error
Next: Solaris 10 zone from flar
From: Michelle on 7 May 2008 08:35
Does anyone know if you can prevent the load sharing for outbound
network traffic when using IPMP? I have some application people who say
this is causing some problems Inbound is easy by just using the IP, but
outbound can use two interfaces/IPs.

Thank you!
Michelle
From: usenetpersongerryt on 7 May 2008 12:20
On May 7, 5:35 am, Michelle <newsgrps0...(a)mst.ca> wrote:
> Does anyone know if you can prevent the load sharing for outbound
> network traffic when using IPMP? I have some application people who say
> this is causing some problems Inbound is easy by just using the IP, but
> outbound can use two interfaces/IPs.

The easiest way I believe is: dont use probe based IPMP.
You give up the pings, use fewer addresses, and you get a warning
during a reboot
but otherwise things seem to work the same for failover and its dead
simple to set up.
Another way is to dicker with the ifconfig flags but Ive never tried
that.
 | 
Pages: 1
Prev: bad PBR sig error
Next: Solaris 10 zone from flar