LabView

How to manipulate with menus and events
Hi   I have an application like the example from Labview called "Menu selection with events" and want to force the event handler to enter a certain stage when the condition is right without having to manually use the menu selection from the front panel. This enables me to implement a command line application... 6 May 2008 23:25

Graphical printout difference in 7.11 and 8.5?
Hi,   I have run into a problem when using the picture functions. I'm using the draw multiple lines function. I'm using this function in LabView 7.11 to draw a dynamic picture and then make a printout of it. When I'm doing it in 7.11 I will get nice smooth lines on my printout. The problem is that we have no... 6 May 2008 22:21

help needed-- error code 1815
Hi gupta.nit?, check your string for the invalid characters. Can you upload your vi, because it�s easier to see what you have done? Mike ... 6 May 2008 22:21

a
Now I wonder where tst got the value 97.7 ;)  LOL! ... 7 May 2008 12:35

error code 1815
i m using 'visa configure serial port' followed by 'visa read' to take input from com1 port. The received signal is spreadhead string. i need to convert it to digital waveform for further processing. there is a VI available for this named 'spreadsheet string to digital.vi'. but while using this VI for the conversion, i... 6 May 2008 22:21

Tab Control Problem
Ok i have the following problem..when I click the run button everytime in labview i want the login  screen to show before any other tab pages..some times it works but sometimes when i stop the program at 3rd page and click run again..the program starts at 3rd page instead of the login screen..how do i correct... 6 May 2008 23:25

I get a not a valid win32 application when I try to run thedownload
I have just downloaded a labview evaluation program.  I get a not valid win32 application error messege.  I tried it on two different PC's.  An xp pro and a win 2000 system.  both give me the same error. ... 6 May 2008 23:25

(Agilent E3631A) Question about switching between channels
Hi!   I have got a problem with my Agilent E3631A. I want to control the machine into switching between +10V and -10V at given intervals of time. This should of course be achieved by switching between channel 2 and 3, but here the big problem arises: When the (+) and (-) are connected through the same wire, a cu... 6 May 2008 22:21

Ways to view a SubVI on the block Diagram
My guess is Modular view. ... 6 May 2008 22:21

Error 1003 while dynamically calling a VI from EXE
Hi,   I added the following key to my application ini file and have added all dynamic code under this folder-  but this didnt help. I still getting file not found error. "visearchPath="C:\test"   i have attached the sample exe which just loads any vi dynamically. Try to load a vi with subvis (... 7 May 2008 03:31