Prev: Graphing data of different data point amounts I get errors
Next: SR830 Help Please
From: Anatoly2 on 8 Sep 2005 11:42
I have looked into this before, but my needs have changed slightly, so I would like to ask again:
 
Using this reference, <a href="http://www.colingordon.com/pdf/Gordon-SPIE99.pdf" target="_blank"> http://www.colingordon.com/pdf/Gordon-SPIE99.pdf</a>, figure 1
&nbsp;
I would like my vibration analysis code to plot the octave spectrum in the same units as captured signal (in this case, microns/sec)&nbsp; If I use the IEC 1/n VI from the SVT, I can only see the power spectrum on the output (signal squared).&nbsp;
&nbsp;
Is there a way for me to produce the octave analysis spectrum in signal units?&nbsp; please help
&nbsp;
(PS this is cross-posted in multifunction DAQ forum, I followed the wizard and the thread was placed there, i didn't notice at first)
 | 
Pages: 1
Prev: Graphing data of different data point amounts I get errors
Next: SR830 Help Please