From: Maxim Levitsky on
The current way of disabling it is not well tested by vendor
and has all kinds of bugs that show up on resume from ram/disk.
A very good example is a dead SDHCI controller.

Old way of disabling is still supported by
continuing to use CONFIG_MMC_RICOH_MMC.

Based on 'http://list.drzeus.cx/pipermail/sdhci-devel/2007-December/002085.html'
Therefore most of the credit for this goes to Andrew de Quincey

CC: Andrew de Quincey <adq_dvb(a)lidskialf.net>

Signed-off-by: Maxim Levitsky <maximlevitsky(a)gmail.com>
Acked-by: Philip Langdale <philipl(a)overt.org>
---
drivers/mmc/host/sdhci-pci.c | 41 +++++++++++++++++++++++++++++++++++++++++
drivers/mmc/host/sdhci.c | 3 ++-
drivers/mmc/host/sdhci.h | 4 ++++
3 files changed, 47 insertions(+), 1 deletions(-)

diff --git a/drivers/mmc/host/sdhci-pci.c b/drivers/mmc/host/sdhci-pci.c
index 65483fd..e021431 100644
--- a/drivers/mmc/host/sdhci-pci.c
+++ b/drivers/mmc/host/sdhci-pci.c
@@ -17,6 +17,7 @@
#include <linux/pci.h>
#include <linux/dma-mapping.h>
#include <linux/slab.h>
+#include <linux/device.h>

#include <linux/mmc/host.h>

@@ -84,7 +85,30 @@ static int ricoh_probe(struct sdhci_pci_chip *chip)
if (chip->pdev->subsystem_vendor == PCI_VENDOR_ID_SAMSUNG ||
chip->pdev->subsystem_vendor == PCI_VENDOR_ID_SONY)
chip->quirks |= SDHCI_QUIRK_NO_CARD_NO_RESET;
+ return 0;
+}
+
+static int ricoh_mmc_probe_slot(struct sdhci_pci_slot *slot)
+{
+ slot->host->caps =
+ ((0x21 << SDHCI_TIMEOUT_CLK_SHIFT)
+ & SDHCI_TIMEOUT_CLK_MASK) |
+
+ ((0x21 << SDHCI_CLOCK_BASE_SHIFT)
+ & SDHCI_CLOCK_BASE_MASK) |

+ SDHCI_TIMEOUT_CLK_UNIT |
+ SDHCI_CAN_VDD_330 |
+ SDHCI_CAN_DO_SDMA;
+ return 0;
+}
+
+static int ricoh_mmc_resume(struct sdhci_pci_chip *chip)
+{
+ /* Apply a delay to allow controller to settle */
+ /* Otherwise it becomes confused if card state changed
+ during suspend */
+ msleep(500);
return 0;
}

@@ -95,6 +119,15 @@ static const struct sdhci_pci_fixes sdhci_ricoh = {
SDHCI_QUIRK_CLOCK_BEFORE_RESET,
};

+static const struct sdhci_pci_fixes sdhci_ricoh_mmc = {
+ .probe_slot = ricoh_mmc_probe_slot,
+ .resume = ricoh_mmc_resume,
+ .quirks = SDHCI_QUIRK_32BIT_DMA_ADDR |
+ SDHCI_QUIRK_CLOCK_BEFORE_RESET |
+ SDHCI_QUIRK_NO_CARD_NO_RESET |
+ SDHCI_QUIRK_MISSING_CAPS
+};
+
static const struct sdhci_pci_fixes sdhci_ene_712 = {
.quirks = SDHCI_QUIRK_SINGLE_POWER_WRITE |
SDHCI_QUIRK_BROKEN_DMA,
@@ -374,6 +407,14 @@ static const struct pci_device_id pci_ids[] __devinitdata = {
},

{
+ .vendor = PCI_VENDOR_ID_RICOH,
+ .device = 0x843,
+ .subvendor = PCI_ANY_ID,
+ .subdevice = PCI_ANY_ID,
+ .driver_data = (kernel_ulong_t)&sdhci_ricoh_mmc,
+ },
+
+ {
.vendor = PCI_VENDOR_ID_ENE,
.device = PCI_DEVICE_ID_ENE_CB712_SD,
.subvendor = PCI_ANY_ID,
diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c
index c6d1bd8..483b78e 100644
--- a/drivers/mmc/host/sdhci.c
+++ b/drivers/mmc/host/sdhci.c
@@ -1687,7 +1687,8 @@ int sdhci_add_host(struct sdhci_host *host)
host->version);
}

- caps = sdhci_readl(host, SDHCI_CAPABILITIES);
+ caps = (host->quirks & SDHCI_QUIRK_MISSING_CAPS) ? host->caps :
+ sdhci_readl(host, SDHCI_CAPABILITIES);

if (host->quirks & SDHCI_QUIRK_FORCE_DMA)
host->flags |= SDHCI_USE_SDMA;
diff --git a/drivers/mmc/host/sdhci.h b/drivers/mmc/host/sdhci.h
index c846813..b1839a3 100644
--- a/drivers/mmc/host/sdhci.h
+++ b/drivers/mmc/host/sdhci.h
@@ -240,6 +240,8 @@ struct sdhci_host {
#define SDHCI_QUIRK_CAP_CLOCK_BASE_BROKEN (1<<25)
/* Controller cannot support End Attribute in NOP ADMA descriptor */
#define SDHCI_QUIRK_NO_ENDATTR_IN_NOPDESC (1<<26)
+/* Controller is missing device caps. Use caps provided by host */
+#define SDHCI_QUIRK_MISSING_CAPS (1<<27)

int irq; /* Device IRQ */
void __iomem * ioaddr; /* Mapped address */
@@ -292,6 +294,8 @@ struct sdhci_host {

struct timer_list timer; /* Timer for timeouts */

+ unsigned int caps; /* Alternative capabilities */
+
unsigned long private[0] ____cacheline_aligned;
};

--
1.7.0.4

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo(a)vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/