Prev: ISE 9.2 and Windriver
Next: high noise/signal in a simple serial to mono dac module
From: u_stadler on 11 Apr 2008 15:50
Hi,

I have the following problem:
I have designed a peripheral with a Fsl bus. It works fine when I
create and EDK Project with micoblaze.
Now I wanted to switch to a Virtex 4 with a Power PC. I know the there
exists and Fcb2Fsl bus brigde.
I searched the xilinx web site and google for some examples or
tutorial how to use and fsl peripheral with the PPC. UnfortunatelyI
couldn't find any so far.
Reading the datasheets I found I tried the following:

I created an EDK project using PPC. I added and FCB Bus, a Fcb2Fsl bus
bridge, 2 Fsl Buses (one for slave one for master) and my peripheral.
I connected them also in this order. so far the hardware synthesizes
but i cant talk to my peripheral. With microblaze there existed a Fsl
bus slot that was defined in parameters.h.
But I can't find something similar for the Fsl bus when I'm using the
PPC. (I understand that the PPC doesn't have a direct Fsl bus
integrated). But shouldn't there be something similar? Like a slot id
for the Bus bridge or the Fcb bus?
Can somebody point me into the right directions? Perhaps a code sample
or a tutorial?

And hints would be appreciated
thanks
Urban
 | 
Pages: 1
Prev: ISE 9.2 and Windriver
Next: high noise/signal in a simple serial to mono dac module