Prev: A required resource was unavailable
Next: Bend angle notes - show included angle
From: Cliff on 6 May 2008 04:49
On Mon, 05 May 2008 19:10:40 -0700, brewertr(a)aol.com wrote:

>"I understand why your shop did not go with HSMWorks. We have a lot of
>work to do. You should see some major functionality enhancements in
>the next month or so."-Jon Banquer-

You have to love the "We."
Then saying that it needs a LOT of "work" ....

"Jon is not affiliated with HSMWorks ApS in any way and that we cannot
control what people are writing on the web."

"Anybody can get evaluation licenses of HSMWorks and test it themselves."

"I hope this clarifies any doubt."
--
Cliff
From: Cliff on 6 May 2008 04:49
On Mon, 5 May 2008 19:52:07 -0700 (PDT), larryrozer(a)yahoo.com wrote:

>Ignorant:

On Mon, 05 May 2008 19:10:40 -0700, brewertr(a)aol.com wrote:

>"I understand why your shop did not go with HSMWorks. We have a lot of
>work to do. You should see some major functionality enhancements in
>the next month or so."-Jon Banquer-

You have to love the "We."
Then saying that it needs a LOT of "work" ....

"Jon is not affiliated with HSMWorks ApS in any way and that we cannot
control what people are writing on the web."

"Anybody can get evaluation licenses of HSMWorks and test it themselves."

"I hope this clarifies any doubt."
--
Cliff
From: Cliff on 6 May 2008 04:50
On Mon, 05 May 2008 20:11:40 -0700, brewertr(a)aol.com wrote:

>[
>They (UG) would like to make me a VAR but I don't have the interest or
>the time.
>]-Jon Banquer -

Or a clue.

>Yep, just like HSMWorks:
>
>"Who I'm working with to deliver what truly will be the next
>generation of CAM: www.hsmworks.com" ]-Jon Banquer-
>
>"I understand why your shop did not go with HSMWorks. We have a lot of
>work to do. "-Jon Banquer-
>
>"Jon is not affiliated with HSMWorks ApS in any way and that we cannot
>control what people are writing on the web. Anybody can get
>evaluation licenses of HSMWorks and test it themselves. I hope this
>clarifies any doubt." - HSMWorks ApS -

None there either it seemed.
--
Cliff
From: Cliff on 6 May 2008 04:52
On Mon, 5 May 2008 20:44:01 -0700 (PDT), larryrozer(a)yahoo.com wrote:

>until the launch of NX 6 and Solid Edge with Synchronous Technology.
>
>Jon Banquer
>San Diego, CA

One should have at least a clue what they are posting about, IMHO.
--
Cliff
From: Half-nutz on 6 May 2008 09:45
On May 5, 10:44 pm, larryro...(a)yahoo.com wrote:
> until the launch of NX 6 and Solid Edge with Synchronous Technology.
>
> Jon Banquer
> San Diego, CA

Don't they consider having Jonnie Nutcase sputtering about their
product a severe form of Slander?

Aren't you afraid of legal problems from slandering ( by association )
another product?
First  |  Prev  |  Next  |  Last
Pages: 1 2 3
Prev: A required resource was unavailable
Next: Bend angle notes - show included angle